OPENER REPAIR
Gate Opener Repair in Corsicana, TX
When an opener quits, the operator itself is often fine. On solar gates out here the usual cause is a battery that no longer holds a charge or a panel shaded or covered in dust; on wired gates it is a board hit by a lightning surge, a failed capacitor, or a limit that has drifted. A safety sensor knocked out of line will also stop a gate from running on its remotes. We test the battery, charging, board, motor and sensors in order and replace the part that failed. US Automatic and LiftMaster are what we install and know best.
SCOPE
What this service covers.
Only the work we actually do — no padded list. If you are not sure whether your job fits, send a photo and we will tell you straight.
Batteries and solar charging
Batteries load-tested and replaced, panels checked for output and shade.
Control boards
Boards diagnosed and replaced after a surge, lightning strike or water in the box.
Motors and arms
Worn motors, gearboxes and operator arms repaired or swapped.
Limits, sensors and remotes
Open and close limits reset, photo eyes realigned, remotes and keypads reprogrammed.
BASED IN CORSICANA, TEXAS — 32.0954° N, 96.4689° W
Why people call about this.
The gate will not open at all
Often a dead battery or a board. Not usually a whole new operator.
It stops or reverses partway
A sensor, a limit setting, or a gate that has started to drag and overload the motor.
The remote stopped working
Could be the remote, the receiver, or a safety device that has dropped the gate to hold-to-run.
RELATED WORK
Often goes with this.
QUESTIONS
Gate Opener Repair — things people ask.
CORSICANA, TEXAS — 32.0954° N, 96.4689° W
CALL FOR A FREE ESTIMATE.
Send a few photos and the address. Cesar will come look at it and give you a straight number — free.